Rough Country 1031 - Manual (Page 2)

3. Remove the inner fender wheel well plastic allowing access to the plastic flare retainers. See Photo 3.
4. Remove the all hardware securing the stock flare to the body using a 8mm wrench. See Photo 4.
5. Remove the stock flare from the Jeep. Locate the appropriate flare and install using the supplied hardware.
Tighten using a 8mm wrench. Slightly snug the hardware. Do not over-tighten the hardware. See Photo 5.
6. Reinstall the plastic inner fender well with the stock hardware and reinstall the plastic trim retainer. The rear
plastic debris flap can be reinstalled if desired. See Photo 6.
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
REMOVE THE INNER FENDER PLASTIC REMOVE THE STOCK HARDWARE
INSTALL THE SUPPLIED HARDWARE REINSTALL THE PLASTIC RETAINER