Rough Country 793 - Manual

JEEP JK REAR LOWER CONTROL ARM SKID PLATE
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.
PRODUCT USE INFORMATION
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts by calling 1-800-222-7023.
This JK rear lower control arm skid plate is designed to work with any JK with stock suspension, a short arm lift kit, or a
Rough Country long-arm lift kit. This is a bolt on skid that helps protect the control arm and adds strength to the control
arm pocket.
Kit Picture
Install Instructions
1. Remove the rear passenger side control arm bolt holding the lower control arm to the axle with a 21mm wrench.
2. Hold the skid against the outside of the control arm pocket and insert the factory bolt through the skid and lower con-
trol arm. See Photo 1.
3. Use a 21mm wrench to tighten the factory bolt. See Photo 2.
4. Repeat on driver side.
92793000
Photo 1 Photo 2