Rough Country 776 - Manual (Page 2)

4. Install the mounting bracket between the sway bar mount and the frame. Use factory bolts and a 16mm socket to
reinstall sway bar mount to the frame. See Photo 3. Repeat on driver side.
5. Rotate the disconnect motor back toward the engine and remove the next casing bolt on the disconnect motor. See
Photo 4.
6. Use the supplied 10mm x 100mm long bolt and nut to attach the disconnect motor to the rubber mount. Insert the
bolt through the rubber mount and install jam nut. Next thread the bolt in the motor case where you removed the fac-
tory bolt. Use a 17mm wrench to jam the nut onto the motor case and a 17mm socket to hold the bolt. See Photo 5.
7. Hold the skid plate up to the mounting brackets and install the 3/8” bolts, washers, and lock nuts using a 9/16”
socket and wrench. See Photo 6.
8. Using a 13/32” drill bit, drill through the front support bar and insert flag nuts on the back side. Use the skid plate as
a template to drill the holes. Use supplied 3/8” bolts, washers, and lock washers and tighten with a 9/16” socket.
See Photos 7 & 8.
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
PHOTO 7 PHOTO 8