Rough Country 329S - Manual (Page 13)

1. Chock the front tires. Raise rear of the vehicle with floor jack.
2. Support the rear with jack stands
3. Remove wheels using a 22mm socket.
4. Remove ABS clip from axle.
See Photo 1.
5. Remove the brake line as shown in
Photo 2 using 13mm.
6. Remove sway-bar link using 8mm and 18mm wrench for lower end and 18mm for top end.
See Photo 3 & 4.
7. Remove the shocks from the axle using 21mm wrench.
See Photo 5.
8. To remove the upper shocks from the frame mount, remove the inner fender well using 8mm socket.
See Photo 6.
There are
10 bolts on driver side and 10 on passenger side. This is done to gain access to nut on back of shock.
Use a socket on back side to remove bolt.
REAR INSTALLATION INSTRUCTIONS
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
REMOVE ABS WIRE CLIP REMOVE THE BRAKE LINE FROM FRAME
REMOVE LOWER SWAY BAR LINK REMOVE THE UPPER SWAY BAR LINK
REMOVE THE LOWER SHOCK HARDWARE REMOVE THE INNER FENDER