Rough Country 394.24 - Manual

Thank you for choosing Rough Country Suspension for your Off Road needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the ve-
hicle. Average professional install time for this kit is 4-6 hours.
Please read all the instructions before beginning the installation. Check the kit hardware against the kit contents list on
the last page. Be sure you have all the needed parts and understand where they go.
Product Use Information
Do no add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height
of the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension
lifts voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied
claims. We will not be responsible for any product that is altered.
This suspension system was developed for 37x12.50 tire on the stock 17” x 9” or 20” wheels at 5” of lift. On an after-
market wheel you will need to purchase a 8” wide wheel with minimum of 4-5/8” of backspacing. When larger tires are
installed, speedometer recalibration is necessary. Due to ride height inconsistencies from the factory you may need to
slightly trim the front plastic valance for proper tire clearance.
This kit can also be used a 3500 single rear wheel truck. Use of this kit on a dual rear wheel pickup is not rec-
ommended. Block and u-bolt combinations may vary with 3500 models.
On vehicles equipped with a two piece driveshaft & carrier bearing as on the Mega Cab, there is the potential
for take off vibration, depending on the severity this can be corrected with shimming down the carrier bearing.
Carrier bearing drop kit Part # 1110 is available from Rough Country. Also 2500/3500 trucks with factory over-
load springs the overload will have to be removed for the new block and u-bolt installation.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun
visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling
characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward
these installation instructions to the vehicle owner for review and to be kept in the vehicle for its service life.
923934000
Tools and Supplies Needed to Install Kit
1. Torque Wrenches 8. Pitman Arm Puller
2. ½” Drive Ratchet and Sockets 9. Hammers
3. Assorted Combination Wrenches 10. C-Clamps
4. Heavy Duty Jack Stands 11. Center Punch
5. Hydraulic Floor Jacks 12. Rubbing Alcohol
6. Channel Locks 13. Safety Glasses
7. Anti-Seize Compound 14. Non- Water Soluble Grease
2008-10 2500 Dodge 5” Lift Kit with Adj. Arms