beautypg.com

Rough Country 1185 User Manual

Page 2

background image

INSTALLATION INSTRUCTIONS

1. After the shock has been removed from the lower mount, install the lower shock bracket as shown in Photo

1 with the supplied 12mm x 65mm bolts, flange locknuts with supplied crush sleeve. Do not tighten at this
time.

2. Install the 5/16” x 3/4” bolts, washers & nuts as shown in Photo 2. Tighten using a 13mm socket / wrench.

3. Tighten the 12mm bolts using a 18mm wrench &

18mm socket.

4. Install the shock absorbers on the new bracket with

the supplied flat washers as shown in Photo 3 on
both sides of the shock and secure with the factory
hardware. Tighten using a 18mm wrench and 15mm
socket. Stock Shocks Shown in picture.

POST INSTALLATION

1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating,

mobile, fixed and heated members. Check steering for interference and proper working order.

2. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine

vehicle service.

Install 12mm x 65mm hardware & crush sleeve

PHOTO 1

Install 5/16” x 3/4” Hardware

PHOTO 2

PHOTO 3

Install Flat Washers here

Thank you for choosing Rough Country for your suspension needs.