Rough Country 9592 - Manual

Page 1
Thank you for choosing Rough Country Off Road Gear for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALATION.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover resistance
by increasing tire track width. In other words, go "wide" as you go "tall".
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts voids
all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will
not be responsible for any product that is altered.
Braking performance and capability are decreased when significantly larger/heavier tires and wheels are used. Take this
into consideration while driving.
The required installation time for this system is approximately 2 hours (see recommended tool list shown below). This kit
is usually sold as a front end leveling kit, but can be sold in combination with rear blocks and u-bolts or a rear add-a-leaf.
Shocks with longer travel are recommended.
This suspension system was developed using 285x75R16 tire on an 8” wheel. Before installing other combinations,
please consult your local tire and wheel specialist.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of our
products.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehicle
of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service.
KIT CONTENTS RECOMMENDED TOOLS
Torsion Bar Adjusters (2) Floor Jack
Heavy Duty Jack Stands
Safety Glasses
Wheel Chock
Torsion Bar Puller Tool
Impack Wrench
18mm Socket
92959200
88-98 Chevy/GMC 1500 Torsion Bar Adjuster Kit