Rough Country 783.22 - Manual (Page 15)

JEEP JK EXHAUST LOOP RELOCATION PIPE
Thank you for choosing Rough Country for your suspension needs.
This exhaust loop relocation pipe kit is intended to gain clearance on the exhaust on the 2012 and up jeep JK.
This pipe is to be used with the Rough Country Longarm kits. This relocation pipe moves the exhaust up out of
the way but still has the same length of the factory exhaust pipe.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Always allow the
exhaust to cool before initiating installation.
Please read instructions before beginning installation. Be sure you have all
needed parts and know where they go. Please review tools needed list and make sure you have needed tools.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts by calling 1-800-222-7023.
92104100
Tools Needed:
11/16” Socket / Wrench
5/8” Socket / Wrench
15mm Socket / Wrench
13mm wrench
INSTALLATION INSTRUCTIONS
1. Loosen the 2 factory bolts on each exhaust flange on the driver side as shown using a 13mm wrench. Measure
down 2.0” from the weld seam of the manifold and mark. Use a reciprocating saw and cut through the factory ex-
haust. Next remove the exhaust from the jeep. See Photo 1 & 2
PHOTO 1 PHOTO 2
Kit Contents:
1-180 Degree Exaust Pipe
1-Exhaust Clamp
1-1041Bag
2-7/16” x 2.5” Bolts
2-7/16” x 3.5” Bolts
2– 7/16 Locking Nuts