Rough Country 597.20 - Manual (Page 4)

25. Install tires and wheels and lower the vehicle to the
ground.
26. Line up the track bar with the hole in the new track bar
bracket. You may have to start the truck and turn the
wheels in the direction the track bar needs to go to help
align the track bar with the hole. Install using the stock
track bar bolt. Tighten bolt.
27. Install the new sway bar links in the factory location with
the factory hardware and using a 18mm wrench. See
Photo 14.
19. Lower the front axle enough to install the new coil springs. Position the coil springs in the lower coil buckets on the
axle and rotate as necessary to be sure that the pigtail of the coil in indexed properly in the bucket. Position the fac-
tory rubber isolator on top of each coil, then raise the axle enough to seat the coil springs in the upper spring buck-
ets.
20. Install the bushings and sleeves on the front gas shock absorbers part # 658459.
21. Compress the front springs enough to install the front shocks. Bolt the lower end of the shock to the axle using the
stock hardware using a 18mm wrench. Attach the upper end of the shock with the stock hardware, using a 19mm
wrench. Tighten only enough to bulge the bushing.
22. Remove the factory steering stabilizer from the factory frame mount using a 19mm wrench. Remove the passenger
side sway bar bracket from the frame using a 15mm wrench.
23. On the passenger side, install the new stabilizer bracket in between the frame and the factory sway bar mount with
the factory hardware and install the stabilizer on the mount with factory hardware. Tighten using a 19mm wrench.
See Photo 12.
24. On the driver side, remove the sway bar bracket from the frame using a 15mm wrench and install the supplied
spacer as shown in Photo 13 with factory hardware.
Photo 12 Photo 13
Photo 14