Rough Country 273N2 - Manual (Page 4)

This kit will level the vehicle without a substantial difference in ride quality. Most customers adjust the front to 2" higher than
stock, and are satisfied with the ride quality. Ride quality is inversely proportional to heights ABOVE a 2" adjustment. This
leveling kit works within the range of the FACTORY droop, or downward suspension cycle. It does NOT bind the CV axles or
ball joints, just as none of these conditions occur with the truck supported on a hoist and the front wheels hanging freely in the
air. As with any lift installed, adjustment of the front headlights is required after installation. Note – the air dam on the front
may need to be trimmed for additional clearance, depending on the tire size.
A front-end alignment should ALWAYS be checked after installing ANY vehicle suspension lift. This kit typically requires
a slight toe-in adjustment. Record the ride height measurement at the time of alignment. If, in the future the torsion bars
settle excessively, alignment can be restored by adjusting-up the bars to their original ride height.
Thank you for purchasing a Rough Country Suspension Lift Kit.
Please visit our website @ www.roughcountry.com for your off road vehicle needs
POST INSTALLATION NOTES