Rough Country 394.23 - Manual (Page 3)

10. On passenger side remove upper control arm bolt on axle side using a 21mm socket and wrench. Remove bolt from
lower control arm on frame side using a 21m wrench and a 1 1/16 socket. Placing a jack under passenger side on
axle slowly move axle forward until upper control arm can be move above axle See Photo 4
11. Install the supplied sleeve then install upper control arm bracket using the supplied 9/16 x 5” long bolts, washers,
and nuts. Make sure new bracket and old upper control arm mount are straight with one another then tighten bolt
using a 21mm and a 22mm wrench. See Photo 5, 6, 7. On some models grinding is required on the factory upper
control bracket edge. See Photo 6
12. Using a 24mm socket remove brake caliper bolts and hang caliper out of the way. See Photo 8 Using control arm
drop bracket as a guide drill all six holes using a 7/16 drill bit. Install the 7/16 x 1.5” long bolts, washers, and nuts
into drilled holes. Tighten bolts using 5/8 and a 11/16 wrench. See Photo 9
13. Reinstall the brake caliper with stock hardware using a 24mm wrench to tighten
GRINDING MAY BE REQUIRED
LINE UP OUTSIDE EDGE
Photo 4
Photo 6
Photo 5
Photo 7
Photo 9 Photo 8