Rough Country 1018 - Manual (Page 2)

INSTRUCTION SHEET
Technical Assistance - (731) 285-9000 Page 2
4. Loosely attach the relocating brackets to the frame using the provided hardware, with flat washers on both the
frame and bracket sides. Reuse the factory bolts if the frame has threaded inserts. The bolts will be tightened
later.
5. Attach the bar body to the bottom of the relocating brackets using the new hardware. Use flat washers on both
sides.
6. Be sure the sway bar body is square in relation to the vehicle frame. The brackets slotted holes can allow the
bar to be misaligned. Torque the bolts to 33 ft. lbs.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 100
miles and then every 1000 miles. Wheel alignment steering system, suspension and driveline
systems must be inspected by a qualified professional mechanic at least every 3000 miles
.