Rough Country 566.20 - Manual (Page 8)

POST INSTALLTION INSTRUCTIONS
1. Adjust steering wheel to re-center prior to driving.
2. Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed,
and heated members. Verify clearance between exhaust and brake lines, fuel lines, fuel tank, floor boards and wiring
harness. Check steering gear for clearance. Test and inspect brake system.
3. Perform steering sweep to ensure front brake hoses have adequate slack and do not contact any rotating, mobile or
heated members. Inspect rear brake hoses at full extension for adequate slack. Failure to perform hose check/ re-
placement may result in component failure. Longer replacement hoses, if needed can be purchased from a local
parts supplier.
4. Have a qualified alignment center realign front end to Caster min– 4.0 degree
Camber –0.6—.09 degree
Toe –.10– .15 degree
5. Install Warning to Driver decal on sun visor.
6. Re-torque all nuts, bolts, and especially u-bolts after the first 100 miles, again after another 100 miles and then check
periodically thereafter.
7. All components must be retightened after 500 miles, and every three thousand miles after installation
8. Adjust headlights to proper settings.
FR SWAY BAR BRACKETS
COIL SPRINGS
FR TRACK ROD BRACKET
PITMAN ARM
FR RADIUS ARM
BRKTS
BUMPSTOP EXTENSIONS
REAR U-BOLTS (4)
RR BLOCKS (2)
FR STABILIZER BRKTS
RR SHOCK ABSORBERS
Thank you for choosing Rough Country for your suspension needs.
FR BRAKE LINE BRKTS
FR BRAKE LINES