Rough Country 777 - Manual

JEEP EVAP SKID
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.
PRODUCT USE INFORMATION
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts by calling 1-800-222-7023.
This JK EVAP skid plate is designed to work with any JK with stock evap canister.
Kit Picture
Tools Needed
9/16” Socket/Wrench
13mm Socket/Wrench
16mm Socket
Install Instructions
1. On 2012 and newer JK’s remove the bottom bracket bolt with a 13mm socket and wrench. See Photo 1. Disconnect
the evap hoses and remove the three factory bolts holding the factory mount to the frame with a 16mm socket.
2. Use the supplied 3/8” bolts, washers, and nuts to attach the mounting bracket to the evap skid plate. Tighten with a
9/16” socket and wrench. See Photo 2.
92777000
Photo 1 Photo 2 PHOTO 2 PHOTO 1