Rough Country 1197 - Manual

FORD F250 CARRIER BEARING DROP BRACKET KIT
92119700
Thank you for choosing Rough Country for your suspension needs .
Please read instructions before beginning installation. Check the kit hardware against the parts list on this page
and the product layout on the last page. Be sure you have all needed parts and know where they go. Also
please review tools needed list and make sure you have needed tools.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of
our products.
INSTALLATION
Kit Contents
1-Carrier Bearing Drop Bracket
1-Poly bag Containing
2-7/16” x 3 1/4 Bolts
2-7/16” washers
Tools Needed:
5/8” wrench
Torque Specs
Size Grade 5 Grade 8
7/16” 45 ft/lbs 60 ft/lbs
1. For vehicles with 2 piece drive shafts, support the driveshaft, using a 15mm socket remove the bolts from
the carrier bearing bracket.
2. Insert the carrier bearing spacer between the bearing bracket and body mount.
3. Reattach the carrier bearing using the supplied 7/16”x 3 1/4” bolts and washers. Torque to 60 ft/lbs. See
Photo 15. Install bracket with flat part on the stock mount and the taper towards the front.
Photo 1
POST INSTALLTION INSTRUCTIONS
1. Check to ensure for adequate clearance between all rotating, mobile, fixed, and heated members.
2. All components must be retightened after 500 miles, and every three thousand miles after installation