Rough Country 397 - Manual (Page 3)

REAR INSTALLATION
(IF PURCHASED WITH KIT)
1. Jack up the rear of the vehicle and place jack stands underneath the frame rail.
2. Remove the tires and wheels.
3. Remove rear shocks using a 21mm wrench. Save the stock hardware it will be used later.
4. Place the floor jack underneath the axle and remove the stock u-bolts. Lower the axle down to allow the blocks to
be installed in between the stock block and the spring perch. Install the new u-bolts and secure with fasteners pro-
vided.
5. Assemble the rear shocks 650396, and install in the stock position with stock hardware, using a 21mm wrench.
POST INSTALLATION
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
4. Readjust headlights to proper settings and take truck in for a front-end alignment to a qualified alignment profes-
sional.