Rough Country 695N2 - Manual (Page 3)

REAR INSTALLATION INSTRUCTIONS
1. Chock the front tires and jack up the rear of the vehicle. Support the rear with jack stands.
2. Remove the tires/wheels.
3. Remove the rear shocks from the lower mount only using a 15mm and 18mm wrench/socket. Retain the hardware
for reuse.
4. Remove the top sway bar bolt using a 15mm wrench/socket. See Photo 1. Retain the factory hardware for reuse.
5. Using the floor jack, lower the rear end and remove the coil springs.
6. Remove the coil spring and the upper coil spring isolator.
7. Remove the lower coil spring isolator and discard as it will not be reused. See Photo 2.
8. Install the new coil spring spacer onto the axle as shown in Photo 3.
9. Install the coil spring and stock upper isolator onto the left side of the axle first. To install the right side you will need
to jack the left side of the axle so that the right side goes down far enough to install the coil spring.
10. Jack up the rear suspension and reconnect the lower new shocks (if purchased with kit) with the factory hardware.
Tighten hardware using 15mm and 18mm wrench/socket
11. Reconnect the sway bar end links and tighten hardware using a 13mm wrench / socket.
12. Reinstall the tires/wheels.
13. Jack up the rear of the vehicle, remove the jack stands and lower the vehicle.
Photo 1
Remove Sway Bar Link from the Frame
Photo 3
Install coil spacer
Photo 4
Photo 2
Reinstall the coil spring
Remove the lower isolator