Rough Country 7572 User Manual
Page 2
7. Using a plumb bob or similar tool, place against coil hat, adjusting to where string does not interfere with coil.
8. Take a measurement from the line of plumb bob and brake caliper and record measurement. See photo 3.
9. Repeat procedure on opposite side of vehicle.
10. Compare the two measurements.
11. If not centered, disconnect rod end and adjust
accordingly using the difference from the compared
dimensions to correctly adjust the tracking.
12. Repeat plumb bob step until tracking is centered.
13. After adjustments have been made and tracking is
centered, tighten jam nut firmly torquing to 75 ft lbs.
14. After installation is complete, test drive vehicle and repeat
the measuring procedure, verifying tracking is centered.
•
Re torque all fasteners after 500 miles and periodically check for tightness.
MEASURE WITH PLUMB & CENTER TRACKING
Photo 3
POST INSTALLATION
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)