Rough Country 1090 - Manual

JEEP WHEEL SPACER KIT
Thank you for choosing Rough Country for all your suspension needs.
Professional knowledge of disassemble/reassembly procedures as well as post installation checks must be
known. Attempts to install these wheel spacers without this knowledge and expertise may jeopardize the integ-
rity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Also please review tools needed list and make sure you
have needed tools.
Kit Contents:
2-1 1/2” Wheel Spacers
92109000
Tools Needed:
19mm Socket
Torque Wrench
Floor Jack
Jack Stands
Flat Head Screwdriver
Installation Instructions
1. Chock the tires and jack up the vehicle.
2. Remove the lug nuts and remove the tire and wheel.
3. Remove the rotor retainer star washers is so equipped using a flat head screwdriver. Removing these will
allow the wheel spacer to sit flat on the rotor surface. These must be removed
4. Install the wheel spacers as shown with the supplied lug nuts. See Photo 1. Tighten to manufacturer specifi-
cations using a 19mm wrench.
5. Reinstall the tires/wheels. See Photo 2. Tighten the lug nuts holding the wheels and tires to factory specifi-
cations. Important note: Please make sure the lug nuts are tightened against the wheel surface. Some
enclosed lug nuts are shorter and can create the illusion that the wheel is tight on the spacers when
in fact the wheel stud is bottomed out inside the lug nut. If this occurs a longer lug nut must be pur-
chased.
Photo 1 Photo 2
Post Installation
1. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine
vehicle service.