Rough Country 9219 - Manual (Page 2)

POST INSTALLATION INSTRUCTIONS
Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed
and heated members. Check steering gear for interference and proper working order. Test brake system.
Perform steering sweep. Check to ensure brake hoses have sufficient slack and will not contact rotating, mobile, or fixed
members, adjust lines/brackets to eliminate interference and maintain proper working order. Failure to perform inspec-
tions may result in component failure.
Re-torque all fasteners after 500 miles. Visually inspect components and re-torque fasteners during routine vehicle ser-
vice.
Readjust headlights to proper settings.
It is the buyer’s responsibility to have all bolts/nuts checked for tightness after the first 100 miles and then every 1000
miles. Suspension components every 3000 miles.
Thank you for choosing Rough Country Suspension for your Off Road needs.
7. Lower the axle to the ground and remove the stock coils springs.
8. Install the new coil springs and new shocks in the same location as stock and jack up the axle to apply light pressure
to the coil springs. Tighten shock hardware.
9. Adjust the cam washers on the lower control arm and retighten the factory hardware.
10. Reattach the sway bar links and tighten using a 15mm wrench.
11. Reattach the brake lines using a 13mm wrench.
12. Install the tires and wheels.
13. Lower the vehicle to the ground.