Rough Country 1011 - Manual (Page 2)

7. Place winch mounting plate in position and align the mounting holes on the plate with the holes on the frame. See
PHOTO 3.
8. Install the supplied bumper brackets as shown on the winch plate. See PHOTO 4.
9. Place the upper bracket on the lower bracket. See Photo 5.
10. Install the bracket using the supplied 10mm x 40mm bolts / washers (TJ only) in the rear holes and the 1/2” x 1 1/2”
bolts / washers as shown in Photo 6. Do not fully tighten at this time.
11. Place the bumper on the bumper brackets and align the hole in the bumper with the brackets. See Photo 7.
12. Install the supplied 1/2” X 1 1/2” button head bolts in the top with supplied lock nuts and in the front holes in the
bumper. If D-ring mounts, stingers or light bars were purchased with this kit, install at this time with the supplied 1/2”
x 1 1/2” button-head bolts using a 8mm allen bit. Tighten the bumper hardware. See Photo 8.
13. Tighten the frame to bracket hardware using a 18mm wrench.
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
PHOTO 7
PLACE THE WINCH PLATE ON FRAME PLACE THE FRAME BRACKET ON PLATE
PLACE THE UPPER BRACKET ON LOWER INSTALL HARDWARE
PLACE BUMPER ON BRACKETS AND ALIGN
PHOTO 8
TIGHTEN BRACKET HARDWARE