Panasonic WV-NF284 - Manual (Page 21)

21
Connections
Step 1
Connect the monitor cable (provided as a
standard accessory) between the monitor out
connector inside the dome cover and the
video in connector of the video monitor (only
when adjusting angular field of view).
Important:
The monitor out connector is provided
only for checking the adjustment of the
angular field of view on the video monitor
when installing the camera or when serv-
icing.
It is not provided for recording/ monitor-
ing use.
Step 2
Connect a power cord from a power supply.
• When using AC 24 V/DC 12 V power sup-
ply
q Remove 3 mm – 7 mm of the outer jacket
of the power cord from a DC 12 V or an
AC 24 V power supply and twist the core
of the power cord to prevent a short cir-
cuit.
Specification of cable (wire):
AWG #16 - #28 Single core, twisted
w Loosen the screws of the provided power
cord plug and insert the power cords into
the power cord plug until the exposed
core wires are completely hidden.
e Tighten the screws to fix the inserted
power cords.
* Make sure that the exposed core wires
are completely hidden after tightening
the screws.
<24 V AC> <12 V DC>
r Insert the power cord plug to the power
cord terminals on the mounting side of
the camera.
* Make sure that the power cord plug is
inserted to the power cord terminal firm-
ly.
INSE RT ADJUST
LOC K
DO
CO
ME
VE R
N
Monitor out connector (for adjustment)
Power cord terminals
Power cord plug
(provided as a
standard accessory)
A B
C
1L 2N
GND
A B
C
@ !
Approx. 3 mm - 7 mm
A
B
C
24 V AC IN
2 N
GND
1 L
12 V DC IN
@
NC
!