Velleman NVR2 - Manual (Page 5)

NVR2
V. 01 – 04/03/2013 5 ©Velleman nv
7. To install a second hard disk, find the supplied hard disk brackets in the package, and fix them to the NVR
base.
8. With the PCB side facing up, connect the hard disk to the power connector and data connector.
9. Place the hard disk in the brackets and fasten it with the supplied screws, two for each side.
10. Put the top cover back in place and fasten the screws.
7. Connection Diagram
Note: To ensure that automatic configuration works well, connect and switch on the IP cameras first. Only then
switch on the NVR.
You can up to 12 IP cameras.
Refer to the illustrations on page 2 of this manual.
A IP camera E monitor supporting high-definition video
B Modem F 19VDC power supply adapter
C Router G NVR back panel
D 8P8C (RJ45) network cable H hub/switch
Connecting the IP camera (plug and play)
1. Connect the camera to a hub/switch.
2. Wait until the camera is configured automatically and the images appear on the monitor.
8. Information and Panels on the Monitor
Refer to the illustrations on page 2 of this manual.
16 NVR status
key lock key unlock
channel lock channel unlock
USB flash drive / device connected no USB device connected
timer recording on timer recording off
overwrite on overwrite off
sequence mode on sequence mode off
PTZ mode on PTZ mode off
CPU load