Milton CAT G200LG4 200kW_250kVA H-100 Control Panel - Manual (Page 2)

FEATURES
• Full range stand-by operation
• Full system status
- 3 phase AC volts
- 3 phase amps
- kW
- Power factor
- Reactive power
- Oil pressure
- Water temperature
- Water level
- Oil temperature (optional)
- Fuel pressure
- Engine speed
- Battery voltage
- Alternator frequency
- Time
- Date
- Transfer switch status
- Run hours
- Service reminders
- Trending
- Fault history (alarm log)
- I2t function for full generator protection
- Built in PLC for special applications • Shutdowns
- Overvoltage
- Overspeed
- Low oil pressure
- High coolant temperature
- Low coolant level
• Remote communication
- RS232
- Optional modem
- Canbus
• Configurable to NFPA 110, level 1 or 2
• Programmable auto crank
• Emergency Stop
• On Off Manual Switch
• Not in Auto flashing light
• Audible alarm for fault condition
• Transfer switch logic communicates with HTS transfer switch
• Weekly exerciser (programmable)
• Selectable Low speed exercise
• Digital voltage regulator with 3 phase sensing (3 phase units)
• Isochronous governor
• Waterproof electrical connectors
• Temperature Range -40° to 70° C
H-100 Controller
Information contained in this publication may be considered confidential.
Discretion is recommended when distributing.
Materials and specifications are subject to change without notice.
CAT, CATERPILLAR, OLYMPIAN, their respective logos and ''Caterpillar Yellow'', as well as corporate and product
identity used herein, are trademarks of Caterpillar and may not be used without permission.
www.CAT-ElectricPower.com
© 2009 Caterpillar
All rights reserved.
Printed in U.S.A. LEHF0039-01 (06/09)