Altronix HubWay EX16S Installation Instructions - Manual (Page 3)

HubWayEX16S Active Hub Unit - 3 -
9. Set illuminated master power disconnect circuit breaker to the RESET (ON) position (Fig. 6, pg. 7) and measure
the output voltage at the power output of each Video Balun/Combiner (Figs. 1b, 1d, pg. 3) before powering each
camera to insure proper operation and avoid possible damage.
• For AC cameras - HubWayAv - Terminals marked [AC POWER] (Figs. 1a, 1b, pg. 3).
• For DC cameras - HubWayDv - Terminals marked [--- 12VDC +] (Figs. 1c, 1d, pg. 3).
10. Connect the BNC connector of HubWayAv or HubWayDv Video Balun/Combiners to the
BNC video outputs of cameras (Figs. 1b-1d, pg. 3).
11. Connect the terminals marked [+ DATA --- ] of HubWayAv or HubWayDv Video Balun/Combiners
to data input terminals of cameras for PTZ control (Figs. 1b-1d, pg. 3). Polarity must be observed.
When using fixed cameras disregard this step.
12. Upon completion of wiring set illuminated master power disconnect circuit breaker to the RESET (ON) position
(Fig. 6, pg. 7).
13. The video signal indicator LEDs (Red) located on the rear of the HubWayEX16S will illuminate when
video signal is present (Fig. 3e, pg. 4). If any of these LEDs are not illuminated, there is no video signal for
that corresponding channel.
1 - White/Orange [VIDEO +]
2 - Orange [VIDEO -- ]
3 - White/Green [DATA +]
4 - Blue [AC 1]
5 - White/Blue [AC 2]
6 - Green [DATA -- ]
7 - White/Brown [AC 2]
8 - Brown [AC 1]
Fig. 2 - CAT5 Wiring Color Codes
VIDEO BALUN/COMBINER
CAT5 + DATA-- POWER
AC
VIDEO
HubWayAv
VIDEO
AC Power
to Camera
Data to
Camera --
+ Data to
Camera
Green Power LED
12VDC Power
to Camera +
--
Red Power LED
Wire
Connectors RJ45 Jack RJ45 Jack
To BNC
Connector
of Camera
To BNC
Connector
of Camera
Structured
Cable from
HubWayEXP
HubSat4D/Di
Structured
Cable from
HubWayEXP
HubSat4D/Di
VIDEO BALUN/COMBINER
HubWayDv
CAT5 + DATA-- -- 12VDC+
--
+
Wire
Connectors
Fig. 1 - HubWayAv and HubWayDv Video Balun/Combiners
Fig. 1c Fig. 1a
Fig. 1b Fig. 1d
HubWayAv passes AC voltage through pins 4, 5, 7, 8 and
[AC Power] terminals. HubWayDv converts AC voltage to DC voltage through
pins 4, 5, 7, 8 and [-- 12VDC +] terminals.