Altronix NetWay8 Installation Instructions User Manual
Page 4
- 4 -
NetWay8/NetWay16
Installing a NetWay1512 adapter for 12VDC IP cameras up to 13W:
1. Mount NetWay1512 in proximity to IP camera (Fig. 2, pg. 4). Affix one side of velcro (supplied) to NetWay1512
and the place the second side of the velcro in the desired location.
2. Connect structured cable from port marked [IN] on
NetWay1512 to any ports marked [OUT] of NetWay
(Fig. 2, pg. 4, Fig. 1a, pg. 3).
3. Connect structured cable from port marked [OUT] on
NetWay1512 to the IP camera (Fig. 2, pg. 4).
4. Connect 12VDC output from NetWay1512 terminals
marked [--- 12VDC +] to the power input of the
IP camera (Fig. 2, pg. 4). Polarity must be observed.
5. Power LED indicator will illuminate on NetWay1512
under normal conditions (Fig. 2, pg. 4).
Installing a NetWay3012 adapter for 12VDC IP PTZ up to 25W:
1. Mount NetWay3012 in proximity to IP camera utilizing mounting hole (Fig. 3, pg. 5). Use a proper fastener and/or
wall anchor when securing NetWay3012M to the wall.
2. Connect structured cable from port marked [IN] on NetWay3012 to ports marked [OUT] of NetWay
(Fig. 3, pg. 5, Fig. 1a, pg. 3).
3. Connect structured cable from port marked [OUT] on NetWay3012 to the IP fixed or PTZ camera (Fig. 3, pg. 5).
4. Connect 12VDC output from NetWay3012 terminals marked [+ 12VDC --- ] to the power input of the
IP camera (Fig. 3, pg. 5). Polarity must be observed.
5. Power LED indicator will illuminate on NetWay3012 under normal conditions (Fig. 3, pg. 5).
Installing NetWayXT repeater module:
1. Mount NetWayXT in desired location utilizing the mounting hole (Fig. 3, pg. 4). Use a proper fastener and/or wall
anchor when securing NetWayXT to the wall.
2. Connect structured cable from port marked [OUT] on NetWay to port marked [IN] on the
NetWayXT (Fig. 3, pg. 4, Fig. 1a, pg. 3).
3. Connect structured cable from port marked [OUT] on NetWayXT to the PoE camera/edge device or next NetWayXT
repeater (Fig. 3, pg. 4).
4. Port status LEDs will illuminate on NetWayXT indicating the port is operational (refer to LED definitions on pg. 4).
5. Power LED will illuminate indicating 12VDC output (Fig. 3, pg. 4).
Port LED definitions for NetWayXT repeater:
Status
Green LED
Yellow LED
OFF
Indicates it is connected as 10Base-T or no link.
Indicates no link.
ON
Indicates it is connected as 100Base-TX.
Indicates a link.
Blinking
---------------------------
Indicates activity.
Fig. 3 - NetWayXT
NetwayXT
Repeater
www.altronix.com
IN
OUT
Power
LED
Structured
Cable from
NetWay
Structured Cable
from IP Camera/
Edge Device
or next
NetWayXT
www.altronix.com
IN
OUT
Netway1512
Adapter
12VDC
--- Output +
-- +
12VDC
Output
Structured
Cable from
NetWay
Structured Cable
from IP Camera/Device
Power
LED
Fig. 2 - NetWay1512