Altronix eBridge4SPT Installation Instructions - Manual (Page 2)

- 2 - eBridge4SK
b. Connect 56VDC UL Listed Class 2 or limited power source to wire insert connector [Power --- Input +] (polarity
observed) (Fig. 1, pg. 2). Use 22AWG-16AWG wire for this connection.
Caution: 56VDC will be present on coax. The other end of the coax should only be connected to the eBridge4SPT.
c. Connect structured cable from ethernet switch/NVR (network video server) to RJ45 jack marked [10/100BaseT]
(Fig. 1, pg. 2).
d. Connect Coax cable to BNC connector marked [Coax] (Fig. 1, pg. 2).
2. eBridge4SPT installation:
a. Attach mounting brackets to eBridge4SPT for wall mount installation (Fig. 3, pg. 7).
Affix rubber pads to eBridge4SPT for shelf installation (Fig. 4, pg. 7).
b. Connect Coax cable from eBridge1SPR to BNC connector marked [Coax] located on the back of the
unit
(Fig. 1, pg. 2).
c. Connect structured cable from IP camera/device to RJ45 jack marked [PoE Output 10/100BaseT] (Fig. 1, pg. 2).
Note: The eBridge is designed to accommodate Megapixel, HD720, HD1080 and VGA (SD) cameras. It is important
to note that some high resolution and high frame rate cameras may demand faster headend processing ability, such as a
PC graphics card to present a quality image. If the headend processing equipment is insufficient in speed, the image may
show pixilation and latency. It is advisable to pretest system if unsure. Alternatively, frame rate and resolution may be
reduced to accommodate system equipment.
Technical Specifications:
Parameter Description
Connections BNC for Coax link. RJ45 for ethernet link.
Input power requirements eBridge1SPR - 51-56VDC/100W @ max. power.
eBridge4SPT - powered by eBridge1SPR.
Indicators Blue: Coax Link.
Yellow (RJ45 connector): On - Link, Off - No Link, Blinking - Activity.
Green (RJ45 connector): On - 100Base-TX, Off - 10Base-T.
Environmental
Conditions Operating Ambient Temperature: UL60950-1 14ºF to 122ºF (-10ºC to 50ºC).
Relative humidity: 85%, +/ --- 5%
Storage Temperature: --- 4º to 158ºF (--- 20º to 70ºC) Storage
Operating Altitude: --- 1000 to 6,561.679 ft. (--- 304.8 to 2000m).
Regulatory Compliance UL/CUL Listed for Information Technology Equipment (UL 60950-1). CE approved.
Weights (approx.) eBridge1SPR - Product: 5.1 oz. (0.144 kg.), Shipping: 7.76 oz. (0.22 kg.)
eBridge4SPT - Product: 2.9 lbs. (1.32 kg), Shipping: 3.9 lbs. (1.77 kg)
Typical Application:
Fig. 1
Coax SLOC
link LED
Up to 1500 ft.
Input
56VDC
Up to 328 ft.
Up to
328 ft.
Up to
328 ft.
Up to
328 ft.
Up to
328 ft.
Ethernet Switch
NVR Network
Video Server
(Head End
Equipment)
eBridge4SPT (back) eBridge4SPT (front)
PoE
Output
10/100
Base-T
eBridge1SPR
IP Camera
IP Camera IP Camera
IP Camera