VEGA VEGABAR 81 4 … 20 mA_HART - Operating Instructions - Manual (Page 42)

42
6 Set up with the display and adjustment module
VEGABAR 81 • 4 … 20 mA/HART
45018-EN-131010
•
French
•
Spanish
•
Russian
•
Italian
•
Dutch
•
Portuguese
•
Polish
•
Czech
•
Turkish
In the delivery status, the sensor is set to the ordered national lan-
guage.
In this menu item you can define the indication of the measured
values on the display.
The default setting for the display value is "Lin. percent".
The display and adjustment module has a backlight for the display.
In this menu item you switch on the lighting. You can find the required
operating voltage in chapter "Technical data".
The lighting is switched off in delivery status.
In this menu item, the device status is displayed.
The respective min. and max. measured value is saved in the sensor.
The two values are displayed in the menu item "Peak values, pres-
sure".
In another window you can carry out a reset of the peak values
separately.
The respective min. and max. measured values of the measuring cell
and electronics temperature are stored in the sensor. In the menu
item "Peak value, temperature", both values are displayed.
Display - Displayed value
1 and 2
Display - Backlight
Diagnostics - Device
status
Diagnostics - Peak val-
ues, pressure
Diagnostics - Peak val-
ues, temperature