VEGA VEGAFLEX 86 Foundation Fieldbus - Manual (Page 95)

95
11 Supplement
VEGAFLEX 86 • Foundation Fieldbus
44233-EN-130910
Fig. 73: Schematic presentation function block Arithmetic
Parameter list
The following table gives you an overview of the parameters used.
FF desciptor Description Unit
PRIMARY_VALUE PRIMARY_VALUE (Linearized value). This is the process val-
ue after min/max adjustment and Linearization with the status
of the transducer block. The unit is defined in "PRIMARY_VAL-
UE_UNIT"
PRIMARY_VALUE_UNIT Selected unit code for "PRIMARY_VALUE"
SECONDARY_VALUE_1 This is the measured value after min/max adjustment with the
status of the transducer block. The unit is defined in "SECOND-
ARY_VALUE_1_UNIT"
SECONDARY_VALUE_1_
UNIT
Selected unit code for "SECONDARY_VALUE_1"
SECONDARY_VALUE_2 This is the distance value ("sensor_value") with the status of the
transducer block. The unit is defined in "SECONDARY_VAL-
UE_2_UNIT"
FILL_HEIGHT_VALUE Filling height. The unit is defined in "FILL_HEIGHT_VALUE_
UNIT"
FILL_HEIGHT_VALUE_UNIT Filling height unit
CONST_VALUE
Constant value
SECONDARY_VALUE_1_
TYPE
Secondary value 1 type
SECONDARY_VALUE_2_
TYPE
Secondary value 2 type
FILL_HEIGHT_VALUE_Type Filling height value type
DIAGNOSIS AITB Diagnosis
DIAG_MASK_1
DIAG_OUT_1