VEGA PLICSRADIO T62 Wireless emitting unit - Manual (Page 24)

24
6 Setup with the integrated display and adjustment unit
PLICSRADIO T62 • Wireless emitting unit (multiple channel)
32624-EN-130228
The service menu contains the following settings:
•
Configuration of the HART input (active/passive)
•
Device assignment
•
Reset
•
Set display language
•
PIN to block the menu
In this menu item, you can define the mode of the HART and
4 … 20 mA input:
•
active (for connection of two-wire instruments without own power
supply)
•
passive (for connection of four-wire insturments with separate
power supply, not available with Ex version)
→
Enter the requested parameters via the appropriate keys and
save your settings with [OK].
When executing this function, the sensor assignment of the three
continuous inputs is updated automatically. This is e.g. necessary if
you want to remove sensors out of the device assignment which are
no longer available.
→
Enter the requested parameters via the appropriate keys and
save your settings with [OK].
With a reset to default, all settings will be reset to default except the
language selection.
Note:
Since the radio parameters are also reset to default, the communica-
tion can be interrupted.
In the menu item "Info" the following information is available:
•
Sensor type and serial number
•
Date of manufacture and software version
Service
Service - Input
Service - Device assign-
ment
Service - Reset
Info