VEGA PLICSRADIO T62 Wireless emitting unit - Manual (Page 23)

23
6 Setup with the integrated display and adjustment unit
PLICSRADIO T62 • Wireless emitting unit (multiple channel)
32624-EN-130228
The emitting and receiving units must be always set to the same radio
channel. When using several independent radio links, each radio link
must be provided with a different channel. In total, seven radio links
are available (channel 0 … 6).
→
Enter the values via the appropriate keys and save your settings
with [OK].
A instrument address must be assigned to each sensor so that
emitter and receiver can communicate. This address must only be
availabe once per radio channel. Enter an individual address between
1 and 6.
Note:
During operation, the addressing of the individual instruments is no
longer carried out via the device address but via the serial number.
After a change of the device address, the inputs in R61 and C62 must
be reassigned (restart device search).
→
Enter the values via the appropriate keys and save your settings
with [OK].
To protect the radio connection against unauthorized wiretapping, the
transmission should be protected by a radio PIN. To do that, activate
this function and enter any PIN (0001-9999).
→
Enter the values via the appropriate keys and save your settings
with [OK].
The displayed value determines which measured values are dis-
played. For VEGA sensors "Percent", "lin. percent", "Scaled" and
"Sensor value" are available. The parameterisation of the connected
sensor is based on the settings "Percent", "lin. percent" and "Scaled".
Enter the values via the appropriate keys and save your settings with
[OK].
When the instrument displays a failure message, further information is
available under the menu item "Diagnosis - Device status".
Device settings - Radio
channel
Device settings - Address
Device settings - Safe
operating mode
Display - Displayed value
Diagnostics