VEGA VEGAPULS 63 (≥ 2.0.0 - ≤ 3.8) Foundation Fieldbus - Manual (Page 37)

This function enables reading out parameter adjustment data as well
as writing parameter adjustment data into the sensor via the indicating
and adjustment module. A description of the function is available in the
operating instructions manual "Indicating and adjustment module".
The following data are read out or written with this function:
l Measured value presentation
l Operation
l Medium
l Standpipe inner diameter 2)
l Vessel form
l Damping
l Linearisation curve
l Sensor-TAG
l Displayed value
l Unit of measurement
l Language
The following safety-relevant data are not read out or written:
l PIN
Copy sensor data
Copy sensor data?
Basic adjustment
If the "Reset" is carried out, the sensor resets the values of the
following menu items to the reset values (see chart):
3)
Function Reset value
Max. adjustment 0 m(d)
Min. adjustment 30 m(d) (VEGAPULS 61, 63, 65)
35 m(d) (VEGAPULS 62, 66)
70 m(d) (VEGAPULS 68)
Medium Liquid
Vessel form not known
Damping 0 s
Linearisation linear
Sensor-TAG Sensor
Displayed value AI-Out
Extended settings None
Unit of measurement m(d)
2) With standpipe versions.
3) Sensor-specific basic adjustment.
Copy sensor data
Reset
VEGAPULS 63 • Foundation Fieldbus 37
6 Set up with the indicating and adjustment module PLICSCOM
28451
-
EN
-120530