VEGA VEGALOG 571 User Manual

Page 42

VEGALOG 571

Now you have to add a name for the meas-
urement loop. Enter in the fields “Meas. loop
No.“ and “Measurement loop description“,
names which clearly identify the measure-
ment loop. It is also possible to configure the
outputs. Depending on the VEGALOG equip-
ment, different output modes are available,
for example,

current output

(

fault signal

only active when under “Configuration meas-
uring system“ at least one switching output
was defined as fault signal output).

Here you can initially choose the card
number (if you have several current output
cards available), then click on the output
numbers and co-ordinate with

to the

measurement loop. It is possible to undo this
co-ordination. When you have finished the
current outputs, click on

. Proceed in the

same way for the other outputs. It is also
possible to adjust the mode (standard - reset
of alarm functions - hold function) with relay
outputs.

In this window, you can clearly see the con-
figuration of your measurement loop. Click to

You have here again the possibility to undo
the measurement loop configuration. Other-
wise click on

. Your measurement loop

configuration is then saved and you see the
main window of VVO again.

After you have finished the measurement
loop configuration, you can start with the
parameter adjustment of the measurement
loop. Click on

Instrument data

, then on

Parameter adjustment

. In the window “Se-

lection of measurement loop - Parameter
adjustment“, you can then select a measure-
ment loop and confirm with

Set-up