Vutec ELEGANTE MOTORIZED - Installation Instructions - Manual (Page 4)

4
Elegante-Rev H 08/30/2010
Suspended Installation
Attach chain links or steel cables (not supplied) to beams or other structural
members.
Install an Eyebolt (supplied) to each bracket (Figure 4). Tighten the hex nuts of
Eyebolt.
Install the brackets to the housing per Dim K as shown in Figure 1a. Tighten
the locking screws to hold the brackets in place.
Hang the screen and be sure it is level.
Electrical
The screen is equipped with an in-line 3-position rocker switch for operation.
No wiring is necessary.
The switch has the UP – OFF – DOWN positions (Figure 5).
All operating switches should be off before power is connected.
Plug the power cable to an easily accessible 120VAC outlet near the Elegante Projection Screen. The screen is ready for use.
120VAC motor
White Neutral
Black AC Hot
Green Ground
Motor Specifications:
Asynchronous motor, capacitor start, 3-stage planetary gear reduction, bi-directional,
intermittent duty.
120VAC, 60HZ, 1.2A, 33RPM, 110Watt
Built-in limit switches
Electromagnetic disk brake, Thermo-overload protection
Operation
Before operating the screen, remove tape and/or foams securing the screen to the housing.
Flip the rocker switch down to lower the screen. The screen will stop automatically when it reaches the lower limit.
Flip the rocker switch up to raise the screen. The screen will stop automatically when it reaches the upper limit.
The screen may be stopped in any intermediate position by returning the rocker switch to the center “OFF” position.
Figure 4
Figure 5