VTech FS6224_-2-21-3 Manual - Manual (Page 39)

35
Answering system settings
Number of rings
You can set the answering system to answer an incoming call
after two, three, four, five or six rings; or toll saver. If you choose
toll saver, the answering system answers a call after two rings
when you have new messages, or after four rings when you have
no new messages. This enables you to check for new messages
and avoid paying unnecessary long distance charges if you are
calling from outside your local area.
Press MENU when the phone is not in use.
Press or to scroll to Answering sys, then press SELECT.
Press or to scroll to Ans sys setup, then press SELECT.
Press or to scroll to # of rings, then press SELECT.
Press or to choose 6, 5, 4, 3, 2 or Toll saver, then press SELECT to
confirm your selection. You hear a confirmation tone.
Remote access code
A two-digit security code is required to access the answering
system remotely from any touch-tone telephone. The preset code
is 19. You can set the code from 00 to 99.
Press MENU when the phone is not in use.
Press or to scroll to Answering sys, then press SELECT.
Press or to scroll to Ans sys setup, then press SELECT.
Press or to scroll to Remote code, then press SELECT.
Use the dialing keys (
0-9) to enter a two-digit number,
or press or to scroll to a desired two-digit number.
Then press SELECT to confirm your selection. You hear a
confirmation tone.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Ans sys setup
# of rings
3
Ans sys setup
Remote code
Remote code
19