Veris Technologies 2000XA Soil EC Mapping System (1997-2008 floppy disk drive 1.76G) - Operating Instructions - Manual (Page 7)

Veris Technologies
Pub. #OM 1CM02-1
7
Note: It is advisable to perform this test on a routine basis (weekly or every 20-25 hours
of data collection) to ensure you are obtaining reliable data.
4) Hitch height—adjust hitch on implement so implement operates level when coulter
electrodes are 1-2” in the soil. The hitch is designed with four possible height positions.
Maintenance and Lubrication
Proper maintenance and lubrication of the Veris Soil Sensor Cart will greatly extend the useful life of
the unit, and Veris Technologies strongly suggests that you follow the following guidelines:
LUBRICATION
Rockshaft pivot points – Each pivot (left and right) contains an upper and lower grease zerk.
Due to the limited motion of the rockshaft, these should be lubricated
on 40-hour intervals.This may vary based on the number of times
the unit is raised and lowered.
Pivot grease zerks