beautypg.com

Veris Technologies 2000XA Soil EC Mapping System (1997-2008 CF card drive 1.77D) - Operating Instructions User Manual

Page 13

background image

Veris Technologies

Pub. #OM 1CM02-1

13

Field Condition

Field should be in a uniform state. Mapping after intensive primary tillage is not recommended. The
soil must have a minimum of 10% available water, and cannot be frozen. If rocky conditions exist, you
may wish to consider the optional coulter rock guard kit , PN 15170.

Pulling Vehicle

The 2000 XA, with its small size and low draft requirement, is designed for ATV use, yet may be
pulled with a variety of vehicles: 4x4 ATV (400cc or larger), small compact tractor, compact or full-
sized pickup. Veris suggests that the unit be loaded for road transport.

Swath width and Navigation

Setting the swath width and navigation system is at the discretion of the customer. A 40-

60’ swath

works well in most areas. In areas of high soil variability, a narrower swath may be preferred.
Several methods of navigation are possible: following previous crop rows, flagging the field, or using
a field navigation computer. While it is important to map in a consistent pattern,

it isn’t absolutely

critical that each pass be exactly the same distance from the previous pass.

Array Selection

The 2000 XA , in the narrow (shallow) configuration, with the adjustable toolbar fully retracted will
investigate the top 2’ of soil. In the wide, fully extended configuration, the array will penetrate 0-3’ of
soil. Adjustment is made by loosening the jam nuts and set screws located on the lower front of each
side of the toolbar, adjusting the toolbar wing extensions, and re-tightening the set screws. Veris
suggests setting the toolbars at either the maximum or minimum setting, not at a point in between. A
limiter bolt determines full extension, so there should be no danger of extending to the point at which
the outside coulters disconnect from the main frame. Important

– do not attempt to combine maps in

which two different investigative depths are used.

Set Screws

Narrow Setting