Velleman projects K8050 Assembly instructions - Manual (Page 10)

10
ATTENTION : the receivers can only be operated by a transmitter allowing address setting. For the setting
of the transmitter, we refer to the manuals of the kits in question.
* K6710 :
To make the transmitter K6710 work with the receiver K8050, the identification of the transmitter must be
adjusted to that of the receiver:
Address 1: mount diode D4
Address 2: mount diode D6
Address 3: mount diode D5
SEVERAL IR RECEIVERS
If you wish to connect more than one receiver to your system, they should be connected in parallel (see below fig
1.0). To preserve the transmission quality it’s advisable to use twin - shielded cable (Ordernr. : PUC2025).
Set-up
1
2
3
4
5
3 2 1 3 2 1 3 2 1
FIG 1.0
SK11