TROY Group Hewlett-Packard LaserJet 9000 Font DIMM Kit Quick-Start Guide - Manual (Page 2)

Font DIMM Printer / Font DIMM Kit
Quick-Start Guide
Document #50-70381-001 Rev. I
Page 2 of 9
STEP 2:
Install the HP PCL 5e Printer Driver for Microsoft
®
Windows
™
NOTE: Use only the TROY Font DIMM Printer and Font DIMM Kit CD to install the Hewlett-Packard
PCL 5e printer driver designated for your Hewlett-Packard printer. Some software screens may
differ slightly in appearance between operating systems.
NOTE: Some of the steps listed below may differ slightly depending on your operating system.
1. Close all applications before installing the HP PCL 5e printer driver.
2. Insert the TROY Font DIMM Printer and Font DIMM Kit CD into your computer CD drive.
3. Before beginning the installation process, you will need to know the operating system you are using on
your computer. If you already know the operating system you are using, proceed directly to step #4. If
you are not sure, right-click on My Computer (located on the Windows desktop), and then click on
Properties to view the type of operating system installed on your computer.
4. From the Start menu, click on Settings, and then click on Printers.
5. Double-click on Add Printer, click on Next, choose Local Printer, and then click on Next. If you are
using Windows 2000/XP, skip down to Step 12, and then proceed with Steps 6 through 11.
6. From the Add Printer Wizard window, click on Have Disk.
7. From the Install From Disk window, click on Browse.
8. From the Open window, click on the down-arrow in the Drives box to select the CD-ROM drive on
your computer.
9. Double-click on the appropriate folder for the operating system you are using (e.g., Win98, etc.).
10. Double-click on the appropriate subfolder for the model printer you are using (e.g., 4200, 9000). If
applicable for your model of printer, be sure to select either the USB or standard parallel (LPT1) printer.
Click on OK to close the Open window, and then click on OK to close the Install From Disk window.
11. Select the appropriate printer driver for you printer model, and then click on Next to continue the driver
installation. You will be given the choice to either replace or keep the existing driver. It is
recommended that you always replace the existing driver. Click on Next to continue. If you are using
Windows 2000/XP, skip down to Step 13.
NOTE: Two versions of the 2300 printer driver (2300 and 2300L) are contained on the TROY Font DIMM
Printer and Font DIMM Kit CD. Use only the 2300 printer driver when installing the TROY Font
DIMM. The 2300L printer driver does not support the TROY Font DIMM.
12. Select the appropriate printer port from the displayed list (usually LPT1), and then click on Next to
continue. If you are using Windows 2000/XP, go back and perform Steps 6 through 11 to complete the
driver installation. Otherwise, for Windows 98SE/ME operating systems, the printer name will be
highlighted.
13. For easy printer identification, it is recommended that you change the highlighted Hewlett-Packard
printer name to the name of the TROY printer you are installing (e.g., TROY MICR 4200 Printer) by
typing over the highlighted printer name. If you want to use this printer as your default printer, be sure
to select this printer as the default printer. If you are using Windows 2000/XP, choose to either share or
not to share your printer over the network.
14. Click on Yes to print a test page to verify that your printer driver was installed correctly, and then click
on Next to continue.
15. Click on Finish to complete the installation. The printer driver installation will proceed automatically
and add the printer icon to the printer folder.