Spicer Wheel Ends Service Manual, Steer & Drive Wheel Ends - Manual (Page 45)

43
Standa
rd
D
rive
A
ssemb
ly
Standard Drive Assembly
After seating bearing at 200 lbs. ft. (271 N•m), Pro-Torq
spindle nut must be backed off. Failure to back off the nut
will cause the bearing to run hot and fail prematurely or
to be damaged. The final adjustment of 100 lbs. ft. (136 N•m)
of adjusting torque with a 1/4 turn backoff will ensure the
necessary 0.001"–0.003" (0.025–0.076 mm) endplay.
7. Insert the keeper ring into the undercut groove of the
spindle nut as shown.
8. Engage the mating teeth of the keeper and the nut.
9. Compress and insert the keeper arms one at a time
into the undercut groove of the nut.
10. Position the keeper ring as required to align teeth.
11. Do not turn the spindle nut to align teeth.
CAUTION
Notches Allow Insertion
of Screwdriver for
Removal and Assembly
Use Raised Nubs
to Indicate Turn
Back Off
1 /
4