beautypg.com

Hs 415 sm model, Disassemble planet carrier unit, Disassembling planetary ring gear unit – Spicer Hub Service Manual User Manual

Page 8

background image

6

Disassemble Planet Carrier Unit

Unscrew and remove carrier capscrews and

washers.

Using chain hoist, carefully remove planet carrier

assembly from axle. Place on bench or press and

support in an upright position with outboard end

of carrier facing down. Remove planet pin by

first removing set screw and then press pin down

(outboard) and out of carrier.

Carefully remove planet gear.

Repeat operations for other planet gear assem-

blies.

Remove and discard O-rings from planet pins.

If thrust button needs changing, pull out of its

position in planet carrier inner face.

Remove sealing compound from planet carrier

and hub mating faces using Loctite Chisel Gasket

Remover or by carefully scraping sealant from

faces.

ax-0138

EXTRACTION

BOLTS

16

11

12

HS 415 SM Model

Disassembling Planetary Ring Gear Unit

Pull out axle shaft complete with sun gear, snap

ring and washer from axle spindle.

Remove snap ring from groove in axle shaft then

pull off sun gear and thrust washer.

Remove lockrings and hub retaining nut from

axle spindle.

Insert extraction bolts into holes provided in ring

gear and tighten evenly to pull ring gear assem-

bly, complete with outer hub bearing cone from

axle spindle.

Remove retraining ring then separate ring gear

from ring gear carrier.

Remove outer hub bearing cone from its position

on ring gear carrier if required.