Spicer Single Drive Axles Service Manual: S140 Series User Manual
Service manual, Spicer, Single drive axles
Table of contents
Document Outline
- AXSM0030_0511.pdf
- General Information
- Important Notice
- Introduction
- Model Listing
- Model Information
- Model Identification
- Part Identification
- Ring Gear and Pinion
- Inspection
- Failure Analysis
- How to Diagnose a Failure
- Prepare the Parts for Inspection
- Find the Cause of the Failure
- Correct the Cause of the Problem
- Inspection
- Inspect Axle Housing
- Inspect Components
- Inspect Primary Gearing
- Differential Carrier Assembly
- Differential Carrier Assembly
- Remove Differential Carrier
- Standard Differentials
- Install Differential Carrier
- Remove Wheel Differential
- Pinion - Parts Exploded View
- Pinion Removal
- Drive Pinion
- Rear Axle Pinion Assembly - Parts Exploded View
- Pinion Installation
- Final Buildup
- Wheel Differential Assembly - Parts Exploded
- Disassemble, Overhaul, and Assemble Wheel Differential
- Disassemble Wheel Differential
- Measure and Adjust Carrier Assembly
- Adjust Backlash and Preload
- Change Backlash Setting
- Measure Ring Gear Runout
- Adjust Ring and Pinion Tooth Contact Pattern
- Install Axle Housing Breather
- Wheel End Seal - Parts Exploded View
- Remove and Overhaul Wheel End Seal
- Adjust Wheel Bearing
- Wheel End
- Verify Wheel End-play Procedure
- Adjust End-play with Tire and Wheel As sembly
- Adjust End-play with Wheel Hub
- Readjust Wheel End-play Procedure
- Lubricate Wheel End
- Lubrication
- Approved Lubricants
- Recommendations for Viscosity/Ambient Temperature
- Lube Change Intervals
- Change Lube
- Drain
- Fill
- Proper Vehicle Towing