MSD 8615 Chevy Small Block 8" Balancer Wheel Crank Trigger Kit Installation - Manual

Figure 1 Pickup Bracket Assembly.
Important: Read the instructions before attempting the installation
Parts Included
1 - Trigger Wheel 2 - Bolts, 3/8" - 16 x 1.5"
1 - Pickup Mount 2 - Bolts, 5/16"- 24 x 1.25”
1 - Centering Ring 3 - Bolts, 3/8" - 24 x 1”
1 - Non Magnetic Pickup 2 - 5/16" Washers
Assembly, PN 8276 4 - Spacers
1 - Mount Retainer Tech Bulletin #104
1 - Locknut
Note: On some vehicles the MSD Crank Trigger Kit
may require slight modifications to accommodate
special engine plates, pulley systems, etc.
INSTALLING THE PICKUP
AND BRACKET
1. Install the pickup mount onto the bracket using
the two fine thread bolts (Figure 1). The mount
retainer will only install one way, do not try to
force the bolts in. Hand tighten the bolts.
2. Install the bracket onto the engine. The bracket
is designed to be used on either side of the
balancer. Be sure to use the correct length bolts
and spacers in the proper locations.
3. Install the pickup and locknut into the holder. Do
not tighten the locknut at this time.
INSTALLING THE TRIGGER WHEEL
The trigger wheel is designed so it can be used on engines with a dry sump oiling system as well as
stock dampers. Two centering rings are included; one for use on stock or most aftermarket dampers
and one for use with a dry sump pump drive mandrel (Figure 2).
Flying Magnet Crank Trigger Kit
Chevrolet Small Block Engines
PN 8610 7" Wheel, 8615 8" Wheel
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.