MSD 82933 Modified Distributor Cap and Rotor for Acura Integra GSR 94-01 Installation - Manual (Page 4)

Figure 10 Crimping the Terminal.
5. Put the assembly into a vise making sure the alignment tabs are on the outside edge of the vise
jaws (Figure 10).
6. Slowly close the vise making sure the tool and terminal stay properly positioned and aligned. Stop
applying pressure when the terminal ends have wrapped securely around the sleeve and grip the
wire.
Note: DO NOT OVER CRIMP! It is possible to tear the sleeve of the wire by excessive pressure on
the vise. This will cause a weaker crimp.
7. Back off the vise and remove
the wire from the Crimper.
Gently tug the terminal and
inspect the position of the
conductor to make sure the
crimp is solid and firm.
M S D I G N I T I O N • W W W . M S D I G N I T I O N . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
© 2010 Autotronic Controls Corporation
FRM27005 Revised 5/10 Printed in U.S.A.
Limited Warranty
M
SD IGNITION warrants this product to be free from defects in material and workmanship under its intended normal
use*, when properly installed and purchased from an authorized MSD dealer, for a period of one year from the date
of the original purchase. This warranty is void for any products purchased through auction websites. If found to be
defective as mentioned above, it will be repaired or replaced at the option of MSD Ignition. Any item that is covered
under this warranty will be returned free of charge using Ground shipping methods.
This shall constitute the sole remedy of the purchaser and the sole liability of MSD Ignition. To the extent permitted
by law, the foregoing is exclusive and in lieu of all other warranties or representation whether expressed or implied,
including any implied warranty of merchantability or fitness. In no event shall MSD Ignition or its suppliers be liable
for special or consequential damages.
*Intended normal use means that this item is being used as was originally intended and for the original application
as sold by MSD Ignition. Any modifications to this item or if it is used on an application other than what MSD Ignition
markets the product, the warranty will be void. It is the sole responsibility of the customer to determine that this item
will work for the application they are intending. MSD Ignition will accept no liability for custom applications.
Service
In case of malfunction, this MSD component will be repaired free of charge according to the terms of the warranty.
When returning MSD components for warranty service, Proof of Purchase must be supplied for verification. After
the warranty period has expired, repair service is based on a minimum and maximum fee.
All returns must have a Return Material Authorization (RMA) number issued to them before
being returned. To obtain an RMA number please contact MSD Customer Service at 1 (888) MSD-7859 or
visit our website at www.msdignition.com/rma to automatically obtain a number and shipping information.
When returning the unit for repair, leave all wires at the length in which you have them installed. Be sure to include
a detailed account of any problems experienced, and what components and accessories are installed on the vehicle.
The repaired unit will be returned as soon as possible using Ground shipping methods (ground shipping is covered
by warranty). For more information, call MSD Ignition at (915) 855-7123. MSD technicians are available from 7:00
a.m. to 5:00 p.m. Monday - Friday (mountain time).