MSD 8876 Harness, MSD 6 to GM Dual Connector Coil Installation - Manual

M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
GM Dual Connector Single Coil Harness
PN 8876
Figure 2 Installation with an MSD 6 or 7 Series Ignition Control.
Figure 1 GM Dual
Connector Coil.
IMPORTANT: Review the Ignition Control instructions before attempting the installation.
The MSD to GM Dual Connector Coil Harness is designed to provide a
splice-free and simple installation of an MSD Ignition Control to GM vehicles
equipped with a Dual Connector Coil (Figure 1).
MSD 6 and 7 Series Ignitions
All of the wires connect to the corresponding colored wires (Figure 2). MSD
7 Series Ignitions share the same color wires.
1. Disconnect the Gray connector followed by the Black connector from the
coil.
2. Connect the Black then Gray connector to the MSD PN 8876 Harness
(Figure 2).
3. Connect the other end of the Harness to the Coil. Note: The connector will
only fit on one side
of the coil. Only two
wires go to the coil
with an MSD Ignition
Control.
4. Connect the four
wires of the Harness
to the MSD Ignition
Control.
Installation with an MSD Timing Control
The PN 8876 may still be used when adding an MSD Timing Control. Figure 3 shows a common
installation.
Figure 3 Wiring an MSD Timing Control with a 6 or 7 Series Ignition.