MSD 8488 Pro-Billet Honda Distributor, 92-95 Installation User Manual
Msd pro-billet honda distributor

IMPORTANT: Read the instructions before attempting the installation.
Parts Included:
1 - Honda Distributor
1 - Parts Bag
1 - Wire Retainer
5 - 90° Boots and Terminals
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative cable first and install it last.
WARNING: The Blaster SC Coil and Coil Driver produce very high voltage and current. Use
caution during installation and while working near the Coil assembly.
Note: The MSD Distributor Cap requires spark plug style 90° terminals and boots, which are supplied.
MSD also offers complete wire sets with the correct terminals and lengths. For more informa-
tion, contact MSD or go to www.msdignition.com.
The MSD Pro-Billet Honda Distributor
must be used with the SC Coil Driver, PN 6305, and Blaster SC
Coil, PN 8235. An MSD SCI, 6-Series and 7-Series Ignition Control may be used, but not required.
REMOVAL
IMPORTANT: Check and establish
the ignition timing prior
to removing the original
distributor.
1. Clean the area around the distributor
and the engine to remove any loose
debris. Disconnect the distributor
connector.
2. Mark the location of each spark plug
wire, then remove the wires from the
distributor (Figure 1).
3. Remove the three 12mm bolts that
secure the distributor to the engine.
Remove the distributor by pulling it
straight out of the engine.
Figure 1 Removing the Wires and Factory Distributor.
DISTRIBUTOR
CONNECTOR
2
3
4
1
2
3
4
1 - Mini-Stripper-Crimper Tool
Components Required:
1 - SC Coil Driver, PN 6305
1 - Blaster SC Coil, PN 8235
MSD Pro-Billet Honda Distributor
PN 8488
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.