MSD 5097 DynaForce Starter, Pontiac_Oldsmobile 326,455 Installation - Manual

MSD DynaForce Starter
Pontiac and Oldsmobile V8, PN 5097
WARNING: Before installing the DynaForce Starter disconnect
the battery cables. When disconnecting the
battery cables, always remove the Negative (-)
cable first and install it last.
IMPORTANT: Proper installation of the DynaForce Starter is important to the overall operation. Correct alignment
of the starter pinion with the ring gear is needed to achieve the best operation and longevity from
your starter. Please read the instructions before attempting the installation.
1. Make sure the starter mounting flange on the engine block is
clean and smooth.
2. Install the starter with the supplied hardware. It is recommended
to leave the shims out until the pinion gear to ring gear teeth
mesh is checked. Torque the bolts to 32 lb-ft.
3. Check that the position of the solenoid is away from direct
heat sources and other components. If there are clearance
problems, the starter housing can be rotated to move the
location of the solenoid. This is done by removing the three
bolts on the mounting block and repositioning the starter
motor (Figure 1).
4. With the starter installed, check the clearance between the ring
gear and the edge of the pinion gear (Figure 2). There should
be at least 1/16". It is recommended to check this clearance
in at least three places around the flex plate.
• If there is not enough clearance, you will need to install
the supplied shim kit by removing the mounting block
(Figure 3). Place the small shim ring in the bearing bore
and install the outer shim on the support housing. Reinstall
the mounting block. This will move the pinion gear into the
starter approximately 0.060".
Figure 2 Checking Pinion Clearance.
Figure 1 Clocking the Starter for Clearance.
CLOCKING
LOCATIONS
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered in our
monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product will help if there
is ever a warranty issue with your product and helps the MSD R&D team create new products that you
ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Starter
2 - Mounting Bolts
2 - Mounting Block Shims
1 - Shim Ring
1 - Outer Shim