MSD 8509 Magnetic Signal Stabilizer Installation - Manual

M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Magnetic Signal Stabilizer
PN 8509
Important: Read these instructions completely before attempting any installation.
The Magnetic Signal Stabilizer converts the signal from a magnetic pickup to a square wave trigger
signal for the MSD Ignition Control.
Parts Included:
1-Magnetic Signal Stabilizer, PN 8509
Mount the PN 8509 away from direct engine heat sources. Use a 1/4" sheet metal screw to mount
the unit.
1. Connect the RED wire to a switched 12 volts and the BLACK wire to ground.
2. Connect the YELLOW wire to the WHITE wire of the MSD Ignition Control.
Figure 1 Wiring Diagram for Magnetic Signal Stabilizer.