MSD 8996 Multi-Channel Digital Ignition Tester Installation - Manual (Page 5)

INSTALLATION INSTRUCTIONS
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Figure 9 Testing an MSD DIS-4 Ignition Control using the PN 89964 Test Harness.
CAM SYNC
PICKUP OUTPUT
NOT USED
CAM SYNC
PICKUP
OUTPUT
NOT USED
NOTE: It may be necessary to jump a 12
volt source to the tester and DIS-4
input. Some vehicles do not supply
12 volts to the coils unless the
engine is spinning.
NOTE: It may be necessary to jump a 12 volt
source to the tester and DIS 2 input. Some
vehicles do not supply 12 volts to the coils
unless the engine is spinning.
Figure 8 Testing an MSD DIS-2 Ignition Control without PN 89962 Harness.
TESTING DIS IGNITIONS
WARNING: Do not connect directly to the coils or this unit will be damaged.
CAUTION: Do not connect more than one channel of the tester unless each spark plug wire is
removed from the spark plug in the cylinders and placed close to ground. If left
connected to the plugs, a spark will occur and could ignite any fuel in the cylinder
resulting in a backfire through the intake.