Longacre 72305 Scale Cart Assembly Instructions - Manual

1) Stand back upri
ght
w. hinge at
top & slide 1 side piece down so
that the two interlock.
2) Position 1 tray (w/o the
sticker) on the floor and align
the screw holes. Just start
the screws only at this point. 3) Position the second tray
about 2” from the top, align
the holes & start the screws
4) Put the lid in place by aligning
the hinge end with the back. Push
the hinge pin in from the side. Be
careful not to bend the pin. 5) Slide the second side down
so that it interlocks like the first
side did - at an angle as shown. 6) Swing the second side
in so it joins the trays.
Start all the screws.
Side
Side
2
trays
lid w. hinge
Assembly Of Scale Cart:
front
support
handle
NOTES:
Assembly should take less than 30 minutes. Only
simple hand tools are required. All screws, nuts, &
washers are included. Freight costs and possible
damage in transit were reduced by shipping this
cart disassembled.
During assembly start the screws only to hold
parts in position. After all assembly is completed
tighten all screws.
Don’t overtighten any of the screws or bolts. They
are self-locking and will not come loose in use.
hinge
pin